Siding Repair in Houston, TX | Westec Construction
Worker on a ladder fastening dark trim boards to an exterior wall, with scaffolding alongside
SIDING

Siding Repair in Houston

Westec Construction handles siding repair in Houston, from a few rotted boards along the bottom of one wall to a full siding replacement on a two-story home. We repair and install fiber cement, vinyl, wood, and engineered wood siding in Houston, Katy, Cypress, Richmond, Conroe, The Woodlands, Sugar Land, and Fulshear.

Siding fails from the inside out in this climate, so we open the wall, fix the rot behind it, and flash it right before the new boards go on. Estimates are free, and every job carries our workmanship guarantee.

Siding repair in Houston: what we fix

Most siding calls we get are for one wall, one corner, or the bottom few feet of a house, not the whole exterior. We repair fiber cement, vinyl, wood, hardboard, and engineered wood siding on homes, and we handle siding on small commercial buildings through our commercial work.

Rot at the bottom courses

The lowest boards on a wall take the worst of it. Rain splashes back off the slab, patio, or flower bed, humidity never lets it fully dry, and sprinklers hit the same spot every morning. Once the paint seal fails, the board goes soft from the bottom up, and wood trim near grade is also where termites tend to show up first. We cut out the bad boards, check the sheathing behind them, and set the new material a proper distance above the hard surface.

Hail, wind, and woodpecker damage

Hail punches holes in vinyl and cracks fiber cement. Wind lifts loose panels and tears off corner trim. Woodpeckers drill wood and hardboard siding, usually up near the eaves. We replace the damaged boards or panels and close every opening before the next storm finds it.

Failed hardboard siding

Hardboard, or composite, siding went on a lot of Houston homes before fiber cement took over. Once the seal at the bottom edge fails, the board drinks water, swells, and crumbles, and patching it rarely holds. We replace failed sections with fiber cement cut to the same exposure, or recommend a full replacement when most of the wall has gone.

Loose, cracked, or buckled panels

Vinyl nailed too tight buckles in summer heat. Fiber cement nailed off the stud, or butted hard to trim with no gap, cracks at the fasteners. We refasten or replace the panel and fix the detail that caused it.

Moisture behind the siding

Stained or bubbling paint, a musty smell inside, and a soft spot that gives under your thumb mean water is sitting behind the siding, not just on it. That is a flashing or house wrap problem, and the only fix is to open the wall.

Repair or replace?

Some siding companies in Houston push a full replacement on every call. Others patch over rot and call it done. The honest answer depends on how much of the wall has failed and what it is made of.

When a repair makes sense

Damage is limited to a few boards or one elevation, the rest is firm when you press on it, and a matching profile is still available. Storm damage, a rotted bottom course, and a loose corner all fall here. A good repair, painted to match, should not show from the street.

When replacement is the better call

Rot shows up on three or four walls, hardboard is swelling across the whole house, or the profile was discontinued and nothing matches. At that point a wall-by-wall repair costs more over time than a siding replacement in Houston done once, with new wrap and flashing underneath. Replacement is also the right time to switch from vinyl or hardboard to fiber cement.

Materials we install

  • Fiber cement, the material most people mean when they say Hardie siding. Holds paint well and shrugs off Houston humidity, hail, and sun better than wood or hardboard. Most of our siding replacement work is fiber cement.
  • Vinyl siding. Lowest cost, color baked in, never needs paint. Vinyl siding in Houston needs room to move; nailed too tight it buckles, so the nailing matters more than the brand.
  • Engineered wood. Wood strands and resin pressed into a board, lighter than fiber cement and easier to cut. It has to stay painted and sealed at every cut.
  • Wood. Cedar or pine lap or board and batten to match an older home. It asks for the most upkeep in this climate.

New siding installation in Houston on an addition or a new build runs the same way, minus the tear-off; see home additions and new construction.

What is under the siding

Siding is the rain screen, not the waterproofing. Behind it should be a house wrap lapped so water runs down and out, flashing at every window, door, and horizontal trim joint, and solid sheathing nailed to dry framing. When one of those is missing or lapped backwards, the siding looks fine while the wall rots behind it.

So on every repair we pull the siding back far enough to see the sheathing. Soft OSB or plywood is cut out to sound material and replaced. If the rot reached a stud, bottom plate, or rim joist, we sister or replace the framing before anything goes back on. Then new wrap, new flashing, and new siding.

Water that got past the siding often made it inside, too, so we handle the drywall repair and interior paint on the other side of the wall as part of the same job.

Black wall lantern mounted on white siding beside the front entry

HOA rules, permits, and Houston clay

Houston has no zoning, but most subdivisions carry recorded deed restrictions, and the master-planned communities around Katy, Cypress, Sugar Land, Richmond, and Fulshear run exterior changes through an architectural review committee. Replacing siding in the same material and color is usually simple. Changing material, profile, or color often needs written approval before the first board comes off, and we handle the submittal.

Inside Houston city limits, permits run through the Houston Permitting Center. A like-for-like siding repair is one thing; opening walls and replacing structural framing is another, and we check what your address needs before the quote is final. In unincorporated Harris and Fort Bend County, it is the county, not the city.

Much of the area also sits on expansive clay that swells in wet months and shrinks in dry ones. When a slab moves, the first signs are often outside: a gap at a corner board, a crack across a panel beside a window, trim pulling away from brick. New siding over a moving foundation does not stay straight, so if we see that pattern we will say so, and our foundation repair crew can look on the same visit.

Worker installing a large window on the upper floor of a white building, with scaffolding beside it

How a siding job goes

A one-wall repair is usually a day or two. A full replacement on a two-story house takes longer, and we give you the schedule before we start.

  1. Site visit and free estimate

    Bryson walks the exterior, probes the soft spots, checks the flashing, and sends a written scope: what comes off, what gets replaced behind it, and what goes back on.

  2. Approvals

    HOA submittals and any city or county permit are handled before the crew is scheduled.

  3. Remove and inspect

    Damaged siding comes off. Sheathing and framing are checked, and any rot is cut out and replaced.

  4. Wrap and flash

    New house wrap and flashing at every opening and joint, lapped so water runs out, not in.

  5. Install

    New siding is cut, gapped, fastened, and caulked to the spacing the manufacturer calls for. Trim and corner boards go on last.

  6. Paint and walk-through

    Fiber cement and wood get primed and painted to match. Then a final walk around the house with you.

What drives the cost

Some siding contractors in Houston quote by the square over the phone. We quote from a site visit, because the price lives in what is behind the boards.

Square footage and height

A two-story wall needs scaffolding or a lift and more time per board.

What is behind it

Rotted sheathing and framing is the swing factor. It cannot be seen until the siding is off, so the estimate says how it is handled.

Material

Vinyl costs the least. Fiber cement and engineered wood cost more in material and labor; wood costs the most to keep up.

Paint and trim

Fiber cement and wood need primer and paint. Replacing corner boards, window trim, and fascia adds to it.

Why Westec

Westec Construction is owner-run by Bryson Oglesby, who scopes every siding job himself and is on site when the wall is open. We take residential and commercial work, we are open 24 hours a day, 7 days a week, and every job carries our workmanship guarantee.

  • Free estimates with a written scope
  • 10% off jobs over $2,500
  • $100 referral bonus, paid after the job is complete.
  • Based in Richmond, working across our service areas

Siding is one trade; a house is several. We paint what we install, fix the drywall on the inside, and take on the rest of the exterior as part of a remodel. Read our reviews, then request a free estimate.

CURRENT OFFER10% off jobs over $2,500.

Mention it when you request your free estimate. It appears on your written scope before any work begins. Offer terms.

Workmanship guarantee included. If our work does not hold up to the standard we promised, we come back and make it right. Details.

Siding questions

How do I know whether my siding needs repair or full replacement?

Count the walls. If the damage is on one elevation or a few boards and the rest is sound, repair it. If rot or swelling shows up on most of the house, the profile is discontinued, or you can see daylight behind a panel, replacement with new wrap and flashing is the better long-term call. The free estimate prices both so you can compare.

Can you match my existing siding?

Usually. Fiber cement and vinyl come in standard exposures and profiles. Discontinued hardboard is the exception: we replace the damaged run with fiber cement cut to the same exposure and paint it to match, and on a lap wall the difference disappears. On a wood house we match the species and the cut.

Do I need HOA approval or a permit to replace siding in Houston?

Often one or both. Deed-restricted subdivisions usually want to approve any change to exterior material or color, while same-for-same repairs are commonly exempt. Inside Houston city limits, structural work behind the siding can need a permit through the Houston Permitting Center. We check your address and handle the paperwork before work starts.

What happens if you find rot behind the siding?

We stop and show you. Soft sheathing is cut back to sound material and replaced, and a rotted stud, plate, or rim joist is sistered or replaced before the wall is closed. The estimate says up front how hidden rot is priced, so there is no surprise. Leaving rot behind new siding is the one thing we will not do.

Does new siding have to be painted?

Fiber cement, engineered wood, and wood all need primer and a finish coat, and factory-primed boards still need paint at every cut end and nail head. Some fiber cement comes pre-finished and only needs touch-up. Vinyl never needs paint. Our painting crew handles the exterior coat, so the siding and the color come from one contractor.

Do you install Hardie siding?

What most homeowners searching for Hardie siding in Houston mean is fiber cement siding, and we install fiber cement along with vinyl, wood, and engineered wood. Tell us the product line you have in mind and we price it on the estimate. Either way the installation follows the manufacturer's published instructions, is flashed and sealed properly, and is backed by our workmanship guarantee.

FREE ESTIMATE

Tell us about the job

Send a few details and Bryson will reach out to set up a free estimate. Prefer to talk? The phone is answered 24 hours a day, 7 days a week.

  • Free estimates, residential and commercial
  • Workmanship guarantee on every job
  • $100 referral bonus, paid after the job is complete.

Ask about 10% off jobs over $2,500. Confirmed on your written estimate.

Prefer to talk? Call or text (281) 809-0006, any time.