Custom Cabinets in Houston
Custom cabinets in Houston start with a tape measure, not a catalog. Westec Construction measures the room, works out the layout with you, and orders cabinets built to your kitchen's measurements. Then our crew installs them, sets the counters, and handles whatever else the job touches, as one general contractor.
Bryson Oglesby owns and runs the company. Estimates are free, every installation carries our workmanship guarantee, and we take 10% off jobs over $2,500. Call (281) 809-0006 or request a free estimate.
What our cabinet work covers
Most of the kitchen cabinets in Houston we replace are not worn out so much as wrong: too few drawers, a dead corner, uppers that stop short of the ceiling. We fix the layout first, then pick the boxes and doors to fit it.
Custom and semi-custom cabinets
Custom cabinets are sized to the inch, so a run ends at the wall instead of at a filler strip. Semi-custom lines use set sizes with a wide choice of doors and finishes, and fit most kitchens for less. Whether the boxes come from a custom cabinet maker in Houston or a semi-custom line, they are built to your measurements and installed by our crew.
Full replacement and installation
Tear-out, wall prep, and cabinet installation in Houston homes that are rarely square: bases leveled, uppers hung on solid blocking, fillers scribed, and crown set so every door lines up before the counters go on.
Refacing, doors, and hardware
Cabinet refacing in Houston keeps sound boxes and replaces what you see and touch: doors, drawer fronts, veneer on the exposed frames, soft-close hinges, and pulls.
Built-ins and vanities
Walk-in pantries, mudroom lockers, bathroom vanities, closet systems, laundry cabinets, and media walls, in the rooms stock cabinets never fit.
Painting and bigger remodels
Sound cabinets in a tired color can be sprayed instead of replaced, which lives on our painting page. Cabinets are also the biggest line in most kitchen remodels and the centerpiece of a bathroom remodel, and the same crew runs the whole job when it grows.





Reface or replace
Open a lower door and look at the sides and back. Plywood boxes that are square, dry, and still fastened to the wall are worth keeping, and refacing them gets you a new-looking kitchen with far less disruption. Particleboard that has swelled under the sink, or shelves that sag, are not worth dressing up.
Layout settles the rest. Refacing cannot add drawers, move the sink, or raise the uppers, so if the problem is where things are rather than how they look, replacement is the honest answer, and we will say so at the estimate. Refacing keeps your counters. Replacement almost always means new countertops, planned with the cabinets.

How a cabinet project runs
Lead time is the long part. The installation itself is days, not weeks, once the cabinets are on site.
Free estimate
We measure wall to wall, check the floor for level and the walls for plumb, note the plumbing and outlets, and talk through how you use the space. You get a written scope.
Layout, selections, and order
Drawings of the new layout, then box construction, door style, paint or stain, hardware, and counters if they are changing. Cabinets are built to your measurements, and demo waits for the ship date.
Demo and prep
Old cabinets out, counters off, walls patched, and any plumbing or circuit that is moving gets moved. Inside Houston city limits that part is permitted and inspected.
Installation
Bases set and shimmed, uppers hung, fillers, crown, and toe kicks fitted, doors and drawers adjusted. Then counters are templated and installed and the plumbing trimmed out.
Walkthrough
Every door and drawer gets opened and the punch list is cleared with you. The installation carries our workmanship guarantee.
What drives the cost
No two cabinet jobs price the same, so we do not post numbers. This is what moves the estimate.
Box construction
Plywood boxes cost more than particleboard and hold up better around sinks and dishwashers. Dovetailed drawers and full-extension slides add to it.
Custom, semi-custom, or stock
True custom sizing and one-off pieces cost the most. Semi-custom covers most layouts for less. Stock is cheapest and least flexible.
Doors and finish
A slab or simple shaker door in paint sits in the middle. Inset doors, raised panels, stained hardwoods, and glass fronts move it up.
Count and configuration
Boxes, tall units, drawers instead of doors, and inside fittings like pull-outs and corner units. Drawers cost more and get used more. Relocated plumbing or circuits add scope on top.
Custom cabinets in Houston homes
Humidity and finishes
Houston air is damp most of the year, and wood moves with it. Solid wood doors swell and shrink with the seasons, so a painted door can show a hairline at the joints in summer that closes back up in winter. That is normal. The box is where moisture matters: plywood holds its shape, particleboard swells if it ever gets wet, and the sink base gets wet first, so we seal the cut edges there.
Floors that have moved
Much of Houston sits on expansive clay that shrinks and swells through the year, and a slab that has moved leaves a floor out of level. A little gets shimmed and scribed out during installation. A lot means a foundation check comes first, because a level run on a moving floor does not stay level.
Permits and approvals
Swapping cabinets in place does not need a permit. Moving the sink, adding a circuit, or taking out a wall does, inside Houston city limits, through the Houston Permitting Center. HOA review does not reach interior cabinets. We do cabinet work in Houston and in Katy, Cypress, Richmond, Conroe, The Woodlands, Sugar Land, and Fulshear. See our service areas.
Why homeowners call Westec
Most cabinet contractors in Houston are either a shop that builds or a crew that installs. We are a general contractor, so one crew measures, orders, installs, and handles the counters, plumbing, and paint around the cabinets (see remodeling). We also do cabinets and casework for commercial spaces. Read our reviews, then get a free estimate.
Owner-run
Bryson Oglesby owns Westec Construction and sets up every estimate, residential and commercial. You deal with the person responsible for the work.
Open 24 hours, 7 days a week
Call (281) 809-0006 any time, evenings and weekends included.
Free estimates
Estimates are free and in writing, and we take 10% off jobs over $2,500.
Workmanship guarantee
Every installation carries our workmanship guarantee. If something we set is not right, we make it right.
Referral bonus
Send us a neighbor and you get a $100 referral bonus, paid after the job is complete.
Mention it when you request your free estimate. It appears on your written scope before any work begins. Offer terms.
Workmanship guarantee included. If our work does not hold up to the standard we promised, we come back and make it right. Details.
Cabinets questions
What is the difference between custom, semi-custom, and stock cabinets?
Stock cabinets come in fixed sizes off the shelf, so the run gets padded with filler strips. Semi-custom lines use set sizes with a wide choice of doors, finishes, and modifications, and fit most kitchens well. Custom cabinets are built to your kitchen's measurements, so a run ends at the wall and a pantry meets the ceiling. We install all three and tell you which your layout needs.
Should I reface or replace my cabinets?
Reface if the boxes are solid, square, and dry and the layout works. You get new doors, drawer fronts, hardware, and veneer, you keep your counters, and the kitchen stays usable. Replace if the boxes are swollen or sagging, or if the problem is the layout, since refacing cannot add drawers, move the sink, or raise the uppers to the ceiling.
How long does a cabinet installation take?
Setting a full kitchen of cabinets takes a few days once they are on site. Countertops are then templated, fabricated, and installed, which adds its own wait. The long part is the order lead time, which depends on the line and finish, so we time demo to the ship date. Refacing is quicker.
Do I need a permit to replace cabinets in Houston?
Not for cabinets alone. Replacing boxes, doors, and counters in the same spots is not permitted work. If the sink moves, a circuit is added, or a wall comes out, and the house is inside Houston city limits, that part is permitted and inspected through the Houston Permitting Center. We pull the permit and book the inspections.
Can I keep my existing countertops with new cabinets?
Usually not with a full replacement. Stone counters rarely come off in one piece, and new boxes almost never match the old ones closely enough for the counter to sit right. Refacing keeps your counters, since the boxes stay put. If you are replacing, we plan new countertops with the cabinets so templating follows the installation.
Tell us about the job
Send a few details and Bryson will reach out to set up a free estimate. Prefer to talk? The phone is answered 24 hours a day, 7 days a week.
- Free estimates, residential and commercial
- Workmanship guarantee on every job
- $100 referral bonus, paid after the job is complete.
Ask about 10% off jobs over $2,500. Confirmed on your written estimate.
Prefer to talk? Call or text (281) 809-0006, any time.
